Yo!
I got my MSZW Mini Marshall Stack in pieces.
Looking into popping in a Footswitch for the Channel Select (Clean to Distortion)
Looks like I need to do the following:
- Take out the Original Switch
- Replace that with a DPDT Relay to the board
- Run power to that Realy (12v ?)
- insert a Jack Socket
THEN....hope my Old Fender channel changer Footswitch I found switches it.
Anyone out there had ago at something similar to this?
Could use a little guidance. I'm pretty tricky with the soldering iron....but not with wiring up switches & relays,
that need power to them...with a relay.....I am over my head here aren't I
